Description

Original transparent front panel for Liebherr freezer drawer 42217749

Original transparent front panel for Liebherr freezer drawer, part number 42217749, dimensions 397 x 212 mm. The part is the transparent front of the freezer drawer, allowing a glimpse of its contents without opening. Fits Liebherr models ICS3214 and ICBP3256 and ICS and ICBP series. Original part only.

Is the transparent panel cracked or broken? Independent replacement is possible in just 15 minutes, without special tools. Check compatibility with your model before ordering.

What is the function of the transparent panel in the freezer drawer?

The transparent panel is the interior of the freezer drawer – it is what you see when you open the appliance door. It allows for quick identification of the drawer contents, maintains proper thermal insulation of the freezer compartment, and protects the frozen food from physical damage. A cracked or broken panel affects the uniform temperature inside the freezer compartment and requires immediate replacement.

The original Liebherr part comes with precise dimensions of 397 x 212 mm , ensuring a perfect fit to the drawer body and requiring no field adjustment. In our experience, non-approved replacement parts do not meet the exact dimensions required and often require “creative solutions” that compromise the drawer’s performance over time.

📋 Technical specifications

✅ Compatible models

• ICS3214
• ICBP3256

Before ordering: Confirm the model number (E-Nr) on the rating sticker inside the appliance. The rating sticker for a Liebherr integrated refrigerator is usually located on the inner wall or inner door lip.

🔧 How do you replace the transparent panel?

Replacing the panel is rated as a simple DIY – requires about 15 minutes and no special tools are required. Difficulty level: Very low.

Replacement steps:

1. Pull the drawer out of the freezer compartment until it stops.
2. Lift the drawer front and release it from the rails.
3. Place the drawer on a stable surface with the panel facing up.
4. Release the side locking tabs (press in) along the edge of the panel
5. Remove the old panel in a straight upward motion.
6. Insert the new panel – watch as the tabs lock with a click
7. Return the drawer to the rails and push it in until it stops.

💡 Tip from the experts

Check the tabs before installation. When our technicians come for service visits, they always check the condition of the locking tabs first – sometimes the panel “unhooks” not because of a break but because of a worn tab. If the tab is broken, the panel will not attach properly even if you install a new part. In this case, contact us before ordering to make sure that no additional part is required.

From the experience of our technicians, approximately 80% of cases of a panel “coming off” are directly related to the locking tabs and not to the panel body itself. Early inspection saves unnecessary ordering.

❓ Frequently Asked Questions

What is the difference between a transparent front panel and a complete drawer?

The clear panel is just the visible front part – the clear plastic face that sits on the body of the drawer. The drawer itself is the large container that holds the food. The panel can be purchased separately from the drawer, which significantly saves on the cost and effort of replacement.

Does a panel that is cracked in just one corner need to be replaced?

Yes. A crack, even a small one, can spread due to freeze-thaw cycles and low temperatures. In addition, a crack in the panel compromises the uniform thermal insulation of the freezer compartment. In our experience, a cracked panel that has not been replaced will often require a complete replacement of the drawer within a few months.

Is it possible to purchase a compatible panel that is not original?

A panel that is not an original Liebherr part may not meet the exact dimensions of 397 x 212 mm. A difference of a few millimeters is enough for the tabs to not lock properly. Our service departments see quite a few cases of damage to the drawer itself as a result of poor fit of non-approved parts.