Description

Original 30W drain pump for Whirlpool washing machine 481073071153

The original Whirlpool drain pump 481073071153 is a 30W replacement part, which allows the machine's drum to drain quickly and quietly at the end of each cycle. The part is designed for the Whirlpool washing machine model RR0678 and is installed in 4 clamps. Genuine component only - not an unapproved replacement.

The machine stopped in the middle of the wash? Water remains in the drum? It's probably the drain pump. A proper replacement with a genuine part gets the machine back up and running in about an hour – without a service call.

What causes drain pump failure?

The drain pump is responsible for pumping all the washing water from the drum to the drain pipe. When it fails, the machine detects that the water has not drained and stops the spin to prevent damage. The first sign is usually an unusual noise during the drain phase, followed by stagnant water. Sometimes an error code appears on the display.

Expert Tip: From our technicians' experience, before replacing the pump, it's always a good idea to check the drain filter in the lower right corner of the machine. In 30% of cases, the problem is simply a clogged filter that hasn't been cleaned, and not a faulty pump.

📋 Technical specifications

✅ Compatible models

• Whirlpool RR0678

To check compatibility with other models – it is recommended to call with the E-Nr number from the sticker inside the door.

🔧 How do you replace the drain pump?

Difficulty level: Medium – requires removing undergarments and working in a prone position. Recommended for a technician.

Before any action – unplug the machine and turn off the water tap.

1. Open the drain filter (bottom right corner) and completely empty the remaining water into a bowl.
2. Remove the bottom front cover panel – usually attached with two to four screws.
3. Disconnect the rubber hoses connected to the pump and loosen the clamps.
4. Disconnect the electrical connector from the pump.
5. Release the 4 clips holding the pump and pull it out.
6. Install the new pump in reverse order – make sure the latches click into place.
7. Reconnect the hoses, clamps, and electrical.
8. Run a short drain cycle and check for leaks.

⚠️ If you choose to replace it yourself – make sure there is no water in the drum before opening the pipes.

💡 Tip from the experts

Clean the filter at least once a month. A clogged filter significantly increases the load on the drain pump and shortens its life. In our experience in the field, most calls for repair of a pump that fails earlier than expected – before the end of its natural service life – turn out to be due to a filter that has never been cleaned.

What not to check yourself: If after replacing the pump the machine still does not drain – the problem may be in the control card or the water level sensor. Contact a qualified technician for diagnosis.

❓ Frequently Asked Questions

What is the difference between a genuine and a non-genuine part for a drain pump?

Genuine Whirlpool 481073071153 part is manufactured to the exact manufacturer's specifications - diameter, motor power, and standard sealing. An unapproved part may physically fit but not provide the exact 30W power, resulting in slow drainage and a short lifespan. In our experience, customers who installed unapproved parts have returned for re-repair in less than a year.

What symptoms indicate a drain pump failure?

Common signs: standing water in the drum at the end of the wash, a loud humming noise during the drain phase, very wet clothes after spinning, a machine that stops in the middle of a cycle, and a small water leak under the machine. If the washing machine displays an error code related to the drain – this is a clear signal that the pump needs to be checked.